Model editor undoing my entries

I am in the model editor view and I am trying to change values for a cylinder in the inspector and whatever I enter is undone. I enter 0.1 for the radius but get 1.00 set. I close the inspector and redo it but same result. I delete the cylinder and start over but no improvement.

Asked by here2infinity on 2020-04-01 21:20:37 UTC

Comments

Answers

After entering your value inside the text box of the model inspector, just make a mouse click outside of the inspector gui. This will solve your undoing thing!!!

Check the link below: ModelEditor Tutorial

Check 4th point under Vehicle construction -> Chassis (its clearly mentioned here)

Asked by Rakesh on 2021-01-11 12:23:21 UTC