Gazebo | Ignition | Community

Attention: answers.gazebosim.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Model editor undoing my entries

I am in the model editor view and I am trying to change values for a cylinder in the inspector and whatever I enter is undone. I enter 0.1 for the radius but get 1.00 set. I close the inspector and redo it but same result. I delete the cylinder and start over but no improvement.

Copyright Askbot, 2010-2011. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.