Gazebo | Ignition | Community

Attention: answers.gazebosim.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Move position of static joint?

Is it possible to control the joint angle of a static joint?

I read that setAngle() command does not work, I have tried modifying joint angle using setModelConfiguration() which does not seem to work either.

Copyright Askbot, 2010-2011. Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.